Diagnosis
The unit is experiencing a total power failure, meaning the electrical circuit is not completing. For the Igloo ICEB26AQ, this is rarely a defective motor or board upon arrival; rather, it is typically caused by the factory-set "shipping mode" where the physical power switch is disabled, or a tripped safety mechanism in the wall outlet.
How to Fix It
Follow these steps to restore power to the control panel:
- Locate the Master Switch: Turn the unit around. On the rear panel, near where the power cord enters the chassis, there is a manual rocker switch. This is separate from the digital buttons on the front.
- Toggle the Switch: Flip the switch to the "ON" or "I" position.
- Verify Power: Check the front LED display. The lights should illuminate immediately, and you may hear a faint click from the internal relay as the compressor prepares to engage.
- Initialize: Press the "Start" button on the control panel to begin the first cooling cycle.
If That Didn't Work
If the lights remain off, troubleshoot the power source:
- Test the Outlet: Plug a lamp or phone charger into the same socket to ensure the outlet is live.
- Reset GFCI: If you are using a kitchen or garage outlet, check if the GFCI (Ground Fault Circuit Interrupter) reset button has popped out. Press it back in.
- Bypass Surge Protectors: Plug the ice maker directly into the wall. Some low-wattage power strips cannot handle the initial "inrush current" required by the compressor.
- Inspect the Cord: Ensure the plug is seated firmly in the socket and check for any visible kinks or damage to the cable.
Heads Up
Once the power is on, the unit must stabilize. Do not be alarmed if the compressor doesn't kick in for 5 to 10 minutes; the system has a built-in delay to protect the refrigerant lines. Additionally, always let the unit sit upright for 24 hours after delivery before plugging it in to allow the coolant oil to settle.