the self cleaning light is blinking and it won't let me make ice, how do i cancel it or make it stop?

Diagnosis

The blinking self-cleaning light on the EUHOMY Nugget Ice Maker indicates that the machine's internal timer has reached its maintenance threshold. This is not a malfunction, but a programmed safety lock. The machine is designed to prevent mineral buildup and biofilm accumulation on the internal freezing cylinder and water lines, which are prone to scaling due to the high-pressure nature of nugget ice production. When this light flashes, the control board enters a "maintenance mode" that disables the ice-making function. The system will refuse to engage the compressor or the auger until the cleaning cycle is either successfully completed or the internal logic is reset. You can confirm this is the issue if the "Ice" button is unresponsive and only the "Clean" indicator is active.

How to Fix It

To clear the blinking light and return the machine to ice-making mode, you must execute a full cleaning cycle. Follow these precise steps:

1. Empty the ice basket completely. If any ice remains, the sensor may prevent the cycle from initiating.
2. Drain any remaining water from the reservoir.
3. Fill the reservoir with a solution of 2 parts distilled water and 1 part white distilled vinegar. For a standard EUHOMY reservoir, this usually means approximately 4 cups of water and 2 cups of vinegar.
4. Press and hold the "Clean" button for exactly 3 to 5 seconds. You will hear the pump engage and the water begin to circulate.
5. Allow the machine to run the full cycle. This typically lasts between 15 and 20 minutes. Do not interrupt the power or open the lid during this process.
6. Once the cycle finishes, the machine will beep and the blinking light will turn off.
7. Drain the vinegar solution from the reservoir and rinse it twice with fresh, clean water to remove any acidic scent.
8. Fill the reservoir with fresh water and press the "Ice" button to resume normal operation.

If That Didn't Work

• Hard Power Reset: If the light continues to blink after a cleaning cycle, the control board may be glitched. Unplug the unit from the wall outlet for at least 10 minutes. While unplugged, press and hold the "Ice" and "Clean" buttons simultaneously for 10 seconds to discharge any remaining capacitors. Plug it back in and attempt the cleaning cycle again.
• Sensor Obstruction: Check the water level sensor (the small probes inside the reservoir). If there is a buildup of lime or scale on the sensors, the machine may "think" it is empty and refuse to start the cleaning cycle, keeping the light blinking. Gently clean the sensors with a cotton swab dipped in vinegar.
• Air Lock Clear: If you hear the pump humming but no water is moving during the cleaning cycle, you may have an air lock. Gently tilt the machine 5-10 degrees forward and backward while the pump is running to help the water prime the internal lines.
• Filter Replacement: If you are using an aftermarket water filter, it may be restricting flow enough to trigger a timeout error. Remove the filter and attempt to run the cleaning cycle with just the water/vinegar solution to see if the light clears.

Heads Up

• Avoid Harsh Chemicals: Never use bleach or abrasive detergents in the reservoir. These can corrode the aluminum freezing cylinder and contaminate the ice. Stick to white distilled vinegar or food-grade citric acid.
• Scaling Prevention: If you live in a hard water area, the cleaning light will trigger more frequently. Using distilled water instead of tap water can extend the time between cleaning cycles and prevent the "clumping" of nugget ice.
• Drainage Maintenance: Periodically check the drain plug at the bottom of the unit. If the drain is clogged with slime or minerals, the cleaning cycle cannot effectively flush the system, which may lead to the light returning prematurely.