Soundbars & Speakers (Page 3)
-
the subwoofer on my bar 300 sounds weak and distorted, like it's rattling.
The soundbar has integrated subwoofers, not a separate unit. Distortion or rattling means a driver is damaged or something is loose inside the cabine…
-
why is there no sound from my rear speakers when using dolby atmos content?
The lack of sound from rear speakers on the JBL Bar 300 is not a technical malfunction, but a result of the hardware architecture. The JBL Bar 300 is…
-
soundbar keeps saying 'bluetooth connected' over and over in a loop, can't use it.
The "Bluetooth Connected" loop on the JBL Bar 300 is typically caused by a handshake failure between the soundbar's internal Bluetooth module and a p…
-
my jbl bar 300 won't power on at all, no lights, nothing. tried different outlets.
The JBL Bar 300 is experiencing a complete power rail failure, meaning the internal circuitry is receiving zero voltage. Because this model utilizes …
-
the soundbar remote works but the buttons on top of the unit itself don't do anything.
The capacitive touch panel on the top of the soundbar has failed or become unresponsive. This is a known fault with the control board. First, unplug …
-
how do i clean the fabric grille on the front without damaging it? it's collecting dust.
The grille is a removable acoustic fabric. Do not spray cleaners directly onto it. Liquid can seep through and damage the drivers behind it. Power of…
-
sound cuts out for a split second every few minutes when using hdmi arc with my samsung tv.
This is an HDMI handshake or bandwidth issue. The TV and soundbar are briefly losing sync on the audio signal. First, replace the HDMI cable. Use a c…
-
subwoofer won't connect to the soundbar, the blue light on the sub just keeps blinking.
The wireless pairing between the soundbar and subwoofer has been lost. They need to be re-paired. Power on both units. On the back of the subwoofer, …
-
the voice dialog is way too quiet compared to the music and explosions, have to keep adjusting volume.
The default audio mode is not optimizing for speech. You need to enable the dedicated Voice Adjust technology. Press the 'Voice Adjust' button on the…
-
there's a constant low humming or buzzing noise from the subwoofer even when no audio is playing.
Ground loop or electrical interference. The subwoofer's power supply is picking up noise from your home's wiring or other devices. First, plug the su…
-
soundbar keeps randomly switching to tv input by itself when i'm using bluetooth.
This behavior is caused by a conflict between the HDMI-CEC (Consumer Electronics Control) protocol and the soundbar's internal input priority logic. …
-
my magnifi mini ax won't turn on at all, no lights, nothing. just dead.
The power supply has failed. This is almost always the AC/DC adapter, not the soundbar itself. Unplug the adapter from the wall and the soundbar. Che…
-
dolby atmos sounds flat, like it's all coming from the front, not from above or behind me.
The AI Room Calibration did not run properly or your source is not sending a true Atmos signal. Re-run the AI Room Calibration. Use the remote, press…
-
soundbar remote works but the buttons on top of the actual soundbar unit do nothing.
The LG S95QR utilizes a capacitive touch interface on the top panel rather than physical tactile switches. When the remote functions perfectly but th…
-
how do i clean the fabric grille on the front of the s95qr without damaging it? it's dusty.
The LG S95QR features a high-density acoustic fabric grille designed to be acoustically transparent while protecting the internal drivers. Because th…
-
getting a weird static crackle or popping noise from the soundbar, especially during quiet scenes.
The static crackle or popping noise occurring during quiet transitions on the LG S95QR is typically caused by "digital silence" gaps or a synchroniza…
-
my lg s95qr subwoofer is powered on but makes no sound, not even a hum or pop.
The LG S95QR utilizes a dedicated 2.4GHz wireless proprietary link to communicate between the main soundbar unit and the subwoofer. When the subwoofe…
-
soundbar turns on but the display just shows 'eARC' and i get no audio from my tv apps.
The soundbar is stuck in a "handshake" loop. When the display shows 'eARC' without producing audio, it means the LG S95QR recognizes a connection to …
-
the rear speakers on my s95qr setup keep cutting in and out, sound drops for a second then comes back.
Wireless interference is disrupting the signal between the soundbar and the rear satellite speakers. Move your Wi-Fi router or any other major wirele…
-
my lg s95qr soundbar just suddenly went silent in the middle of a movie, no sound at all from any channel.
The sudden loss of audio across all channels on the LG S95QR typically indicates a "handshake failure" or a firmware deadlock within the main process…
-
the sound cuts out for a split second every so often, mostly when using hdmi, driving me nuts.
This is an HDMI handshake or signal integrity issue. The TV and soundbar are briefly losing sync on the digital audio signal. First, replace the HDMI…
-
trying to connect via bluetooth but my phone just won't find the bose tv speaker, the light isn't blinking blue.
The soundbar is not in Bluetooth pairing mode. It defaults to seeking an audio input from the TV. The LED needs to be in a specific state to be disco…
-
how do i clean the fabric grille on the front without wrecking it? it's getting dusty.
Dust and debris are caught in the polyester fabric grille. The grille is not removable on the TV Speaker model, so you must clean it in place. Use a …
-
there's a low humming or buzzing noise coming from the speaker even when nothing is playing.
This is almost always a ground loop or electrical interference, not a faulty speaker. It's introduced through the audio cable connection. If using th…
-
just got this and the dialogue mode button on the remote does nothing, voices still sound muffled.
The Dialogue Mode is likely already active. The button toggles the mode on or off; there's no distinct indicator light for it on the soundbar itself.…
-
soundbar keeps turning off by itself after like 20 minutes of no sound, how do i stop the auto standby?
This is the Auto Standby feature. It's designed to save power when no audio signal is detected for 20 minutes. It is enabled by default. To disable i…
-
bose tv speaker remote won't change volume or turn it off, only the buttons on the bar work.
The remote's IR signal isn't reaching the soundbar's sensor, or the remote batteries are dead. Obstruction or distance is the most common cause. Repl…
-
my bose tv speaker soundbar just has a steady white light and no sound is coming out of it, what gives?
The soundbar is powered on but not receiving an audio signal from your TV. The steady white LED indicates normal standby/power-on state. Check the HD…
-
how do i get the soundbar to turn off automatically with the tv? it just stays on in standby.
The Auto Power Link feature, which uses HDMI-CEC, is either disabled or not communicating properly with your TV. Enable Auto Power Link on the soundb…
-
there's a weird popping or crackling sound from the speakers sometimes, especially during quiet scenes.
This is almost always an issue with the digital audio signal from your TV, either due to a poor HDMI connection, incorrect audio format, or signal in…
-
my soundbar won't connect to bluetooth from my phone anymore, it just says pairing failed.
The soundbar's Bluetooth pairing list is full (it stores about 8 devices) or has a corrupted entry, preventing new connections. Clear the entire Blue…
-
is there a way to clean the fabric cover on the s800b without damaging it? it's collecting dust.
The magnetic fabric grille is a dust magnet. Vacuuming or improper wiping can push dust into the speaker holes or snag the fabric. Remove the grille …
-
the voices in movies are way too quiet but explosions are loud on my hw-s800b, how do i fix this?
This is a common dynamic range issue. The soundbar is receiving a high-quality, uncompressed audio signal (like Dolby Digital) with wide volume diffe…
-
soundbar turns on with the tv but the volume buttons on my samsung remote do nothing, have to use the soundbar remote.
AnHDMI-CEC (Anynet+) handshake issue. The TV sees the soundbar but isn't passing through remote control commands properly. Reset the HDMI-CEC connect…
-
why does my ultra slim soundbar keep disconnecting from wifi? i have to keep adding it in the smartthings app.
The S800B's Wi-Fi module struggles with certain router bands or congestion. It's dropping its connection to your network and thus disappearing from S…
-
my samsung s800b soundbar just flashes red on the front and won't play any sound, what's wrong?
The red LED flash is a general protection mode, almost always triggered by an electrical fault in the connection to the subwoofer. The soundbar shuts…
-
the volume on my ray is way out of sync with my tv remote, like i have to crank it to 50 just to hear a conversation.
This is usually a mismatch between your TV's optical output level and how the Ray is interpreting it. Some TVs send a very low-level signal via optic…
-
can i clean the fabric grille on my ray? it's getting dusty and i'm scared to ruin it.
You're right to be careful—the grille is not removable for washing, and liquids are the enemy. Dust and light smudges are the main things you'll deal…
-
my ray is making a faint static or hissing sound when it's on but not playing anything, is that normal?
A low-level electronic hiss from the speakers when idle is generally normal for active speakers like the Ray, but it shouldn't be loud enough to hear…
-
the white light on my ray is just solid white and it won't respond to anything, the app says it's disconnected.
A solid white light means the Ray is powered on but not connected to your Sonos system. It's in a kind of limbo state, often after a power surge or n…
-
i'm trying to set up my new ray but the sonos app just won't find it, it's stuck on 'searching for products'.</p>
The most common setup blocker is your phone being on a different Wi-Fi band (5GHz) than the Ray (2.4GHz only). Your phone and the Ray need to be on t…
-
the sound from my ray sounds really tinny and hollow, like it's coming from a tunnel, no bass at all.
This happens when the Ray is set to "Speech Enhancement" mode, which boosts vocals at the expense of all other sound, making music and movie scores s…
-
sonos ray keeps randomly disconnecting from wifi and i have to unplug it to get it back, super annoying.
This is usually a Wi-Fi interference issue. The Ray only uses a 2.4GHz Wi-Fi band, which is crowded and can get shaky if your router is too far away …
-
my sonos ray is connected to my tv with optical but there's no sound at all, tv audio is still coming from the tv speakers.
Your TV isn't sending the audio signal to the soundbar. Most modern TVs don't automatically switch their audio output to the optical port when you pl…
-
the partyboost feature isn't working, my charge 5 won't connect to my friend's flip 6
PartyBoost is finicky about sequence and existing connections. You cannot mix with older JBL Connect+ speakers. On the *first* speaker, press the Par…
-
my jbl charge 5 sounds tinny or like the bass is completely gone after i dropped it
The internal passive radiators (the oval grills on the ends) have likely become stuck or unseated from the impact, killing the low-frequency response…
-
the usb-c port on my charge 5 feels loose and the cable falls out or won't charge reliably
The USB-C port on the JBL Charge 5 is a surface-mount component soldered directly to the main PCB. When the port feels "loose" or cables fail to clic…
-
can't get my charge 5 to enter pairing mode, the bluetooth light just isn't blinking
The JBL Charge 5 utilizes a "sticky" connection logic where the speaker will prioritize any previously paired device within range, preventing the Blu…
-
my charge 5 battery drains super fast even when it's turned off, like overnight
The JBL Charge 5 is experiencing a "parasitic drain," where the internal lithium-ion battery continues to discharge despite the device being powered …
-
how do i clean the fabric grill on my charge 5 without ruining it? it's got dust and a small stain
The JBL Charge 5 features a tightly woven, hydrophobic polyester fabric wrap designed for IP67 water and dust resistance. However, the weave acts as …